Turn Signal Switch Removal & Replacement

Turn Signal Switch Removal & Replacement

Turn Signal Switch Removal & Replacement Guide

Classic Ford Mustang, Falcon, Fairlane, Comet & F-Series Trucks (1960s–1970s)

If your turn signals are acting up—or just plain dead—it’s often the switch inside the column calling it quits. The good news? This is a very doable repair with basic tools and a little patience. Below is a step-by-step guide to replacing classic Ford turn signal switches, including popular part numbers like C3OZ-13341-B, C5OZ-13341-B, C5OZ-13341-HQ, C9TZ-13341-C, and C9TZ-13341-USA.


Why Replace Your Turn Signal Switch?

A worn or failing turn signal switch can cause:

  • Intermittent or non-functioning signals
  • Brake light issues
  • Horn malfunctions (shared circuit in many models)

Replacing it restores proper electrical function and keeps your classic Ford safe—and road legal.


Tools & Prep

  • Steering wheel puller (TOOL-3600)
  • Small crescent wrench
  • Screwdrivers
  • Dielectric grease
  • Phone (for reference photos—trust me on this one)

First rule: Disconnect the battery ground cable. Always.


Step-by-Step Removal

1. Remove the Turn Signal Lever

Twist the lever out. If it’s stubborn, use a small crescent wrench on the flat spot found on most originals.

2. Remove Horn Button or Ring

Push down and turn left to release.
⚠️ Go slow—there’s a spring underneath that likes to make a break for freedom.

  • Inspect horn ring retainer
  • Remove horn brush if equipped

3. Pull the Steering Wheel

Use your steering wheel puller (TOOL-3600) and set the wheel aside.


4. Document Wiring (Critical Step)

Before disconnecting anything:

  • Take clear photos of wire routing and colors
  • Or write them down if you're going old-school

Some 1965+ models use connectors that may require a release tool.


5. Disconnect Wiring Under Dash

Unplug the turn signal switch harness from beneath the dash.


6. Remove the Turn Signal Switch

Back at the column:

  • Remove the (3) mounting screws ONLY
  • Do NOT remove the two large nuts (unless you enjoy fishing dropped studs out of a column…)

Carefully pull the switch upward while feeding the wires out of the column.


Installation Process

7. Compare Old vs New Switch

Before installing:

  • Match wire colors and count
  • Confirm lever compatibility

8. Install New Switch

  • Feed wires down through the column
  • Seat the switch properly
  • Reinstall the (3) retaining screws

9. Reconnect Wiring

  • Plug into under-dash harness
  • Apply dielectric grease to connections for longevity

10. Reassemble Column

  • Reinstall steering wheel
  • Install horn brush (if applicable)
  • Replace spring, horn button/ring
  • Thread in turn signal lever (don’t over tighten)

Final Check (Moment of Truth)

Reconnect the battery.

Now…

  • No smoke? Good sign.
  • No weird noises? Even better.

Turn the key and test:

  • Turn signals
  • Brake lights
  • Horn

If everything works—you nailed it.
If not… well… time to retrace those wiring steps.


Pro Tips from the Shop Floor

  • Always photograph wiring before disassembly—memory lies, photos don’t
  • Replace worn horn components while you’re in there
  • Use dielectric grease to prevent future corrosion issues
  • Never force the switch or lever during install

Need the Right Turn Signal Switch?

At C&G Ford Parts, we’ve been helping restorers get it right since 1978. Every part we carry is built for proper fitment and factory-correct function—because guessing doesn’t belong in a restoration.

👉 Browse our selection of classic Ford turn signal switches and get your signals back in sync.



Leave a comment

Please note, comments need to be approved before they are published.

MORE CLASSIC FORD INSIGHTS

Tail Light Harness Replacement Guide for 1960–1965 Falcon, Ranchero, and Comet Wagons

Tail Light Harness Replacement Guide for 1960–1965 Falcon, Ranchero, and Comet Wagons

Why This Job Matters This isn’t just about lights—it’s about safety and reliability. A fresh harness eliminates voltage drops, intermittent faults, and those “works when it feels like it” gremlins. It’s one of those upgrades that doesn’t show at the car show, but you’ll feel it every time you drive.
Evolution of Ford Generators

Evolution of Ford Generators

The evolution of the early Ford generator is a fascinating journey through the annals of automotive history, showcasing Ford's pioneering role in electrical system innovation. From the early 1900s to the 1950s, Ford generators underwent significant transformations in design and output, reflecting the increasing electrical demands of automobiles. 1920s: The Birth of the Ford Generator In the 1920s, Ford transitioned from the magneto system to actual generators. These early generators, used in models like the Model T, were a leap forward in automotive electrical systems. They typically produced about 6-8 volts and 10-15 amperes. This was a modest output, but it marked a significant improvement over the earlier systems, providing more reliable power for lighting and ignition. 1930s: Advancements in Power Output By the 1930s, as vehicles incorporated more electrical components, classic Ford generators evolved to meet these new demands. The output increased to approximately 12 volts, with the current rising to around 30-40 amperes. This improvement was crucial in powering additional features like radios and heaters, which were becoming standard in vehicles. 1940s: Post-War Technological Growth Post-World War II, the 1940s saw further advancements in Ford generators. The output stabilized around 12 volts, but the current capabilities expanded, reaching up to 40-50 amperes. This era's generators were more efficient and reliable, reflecting technological advancements and the growing complexity of automotive electrical systems. 1950s: The Peak of Generator Technology The 1950s represented the peak of generator technology before the transition to alternators. Ford generators during this decade were robust, producing 12 volts and capable of up to 50-60 amperes. This increased capacity was essential for powering more sophisticated electrical systems, including advanced lighting, climate control, and entertainment systems. In conclusion, the evolution of the early Ford generator from the 1920s to the 1950s is a testament to Ford's innovation in automotive technology. Each decade brought significant improvements in output and reliability, mirroring the evolution of automobiles themselves. From the humble beginnings of powering basic vehicle functions to meeting the demands of more complex and luxurious features, Ford generators played a crucial role in the advancement of automotive electrical systems.
The 1955 Ford Fairlane: A Classic Icon of American Automotive History

The 1955 Ford Fairlane: A Classic Icon of American Automotive History

The 1955 Ford Fairlane: A Classic Icon of American Automotive History In the realm of classic American automobiles, the 1955 Ford Fairlane stands out as a significant model that marked Ford's return to prominence in the auto market. Named after Henry Ford's estate, Fair Lane, in Dearborn, Michigan, the Fairlane was introduced as Ford's premier car for that year. With a new frame and 11" brakes, the Fairlane replaced the Crestline as the flagship offering. Design and Styling The 1955 Fairlane was distinguished by its elegant and modern styling, characterized by a lower, longer, and wider profile compared to its predecessors. It featured a distinctive stainless steel stripe running along its side with striking 2 tone paint schemes, which became a hallmark of the Fairlane models. The car was offered in six different body styles, including two- and four-door sedans, hardtop, and a convertible known as the Sunliner. A standout among these was the Crown Victoria, which boasted a tinted, transparent roof panel, adding a futuristic touch to its design. Engine and Performance The Fairlane came equipped with options for both a 223 cubic inch (3.7 L) straight-six engine, a 272 cubic inch (4.5 L) V8, or a 292 cubic inch V8 (4.8 L) with a 4 barrel carb providing buyers with choices tailored to different performance needs. The V8, in particular, was a point of interest for its power and smooth operation. Transmission options included a Fordomatic automatic or a three-speed manual. Market Impact The introduction of the Fairlane was part of a broader effort by Ford to rejuvenate its lineup and recapture market share from competitors like Chevrolet. The Fairlane was not just a vehicle; it was a statement of Ford's commitment to innovation and style. In 1955, Ford managed to outsell Chevrolet, ending a 20-year streak where Chevy had been the best-selling car in America, a testament to the Fairlane's appeal and Ford's strategic marketing. Features and Accessories Ford emphasized luxury and convenience with the Fairlane. It included features like dual exhaust systems on higher-end models which improved both performance and sound. The car also introduced several firsts, including Ford's first factory-installed air conditioning system, known as "Select Aire," which was optional. Innovations like the panoramic windshields, new for 1955, offered drivers a broader view, enhancing safety and driving experience. Cultural Impact The 1955 Fairlane wasn't just a car; it became an emblem of the era's optimism and love for automotive style. Its design and engineering influenced subsequent Ford models and left a lasting impression on American car culture. The Fairlane's success helped pave the way for future models, including the introduction of the Fairlane 500. Legacy Today, the 1955 Ford Fairlane is celebrated by collectors and car enlthusiasts for its blend of style, performance, and historical significance. Restorations are common, and the car's parts are sought after, with companies like Classic Industries providing a range of reproduction parts for enthusiasts looking to bring their Fairlane back to its original splendor. In conclusion, the 1955 Ford Fairlane was more than just another car on the road; it was a symbol of Ford's resurgence and a reflection of the vibrant automotive culture of the 1950s. Its design, performance, and the enduring legacy it left behind continue to make it a beloved piece of automotive history.